splined shaft

splined shaft

[′splīnd ′shaft]
(design engineering)
A shaft with longitudinal gearlike ridges along its interior or exterior surface.
References in periodicals archive ?
Pump d-163 2 * 1 inch 3/8 splined shaft (3053.001) italy
In a report filed with the Ministry of Land, Infrastructure, Transport and Tourism, the company said the propeller shafts of the trucks, manufactured between September 2002 and November 2010, could fracture or fall off due to cracks at the weld point of the propeller shaft's pipe and splined shaft.
During operation the rotor is driven by a splined shaft coupled to the drive unit.
Then pull the crank off the splined shaft. To replace, insert the spring clip in the grooves on the crank and push the entire crank onto the splined shaft until it "clicks."
A variety of output shaft options are available including 32 ram, 1.25 in., 1.50 in., keyed, tapered, and splined shaft versions, as well as a variety of port options to increase design flexibility.
A stainless steel splined shaft coupled to a stainless steel lead screw allows for precise motion control with resolutions ranging from 0.0005 in.
It consists of a recirculating ball bearing mated to a splined shaft. With less friction to deal with, Dynamex engineers can specify a smaller motor for the reciprocating motion.
A 50 mm straight shaft is standard, while a 60 mm, tapered shaft and 2.125 in., 16-tooth splined shaft are also available.
(5-way) 1 pc, 3) pump d-163 2 * 1 "3/8 splined shaft (3053.001) -1 pc, 4) regulator (valve) 4-section with pressure gauge 16 bar assembly-1 pcs, 5) suction filter -1 pcs, 6) cardan shaft lz = 680 32 * 38 * 8- 1 pc, 7) hoses pvc for cpp armor 12.5 * 3.0 - 50 m 8) hoses 25 * 34-2 , 5- 2500 m, 9) clamps 12-20 mm stainless 9 mm-82 pcs, 10) clamps 25-40 mm stainless steel -4 pcs, 11) clamps 40-60 mm
Heavy-duty air cleaners are now available for the EH41, EH65 and EH72 series; and splined shaft configurations for the EH65 and EH72 engines.
Based on the use of a symmetrical, hammered splined shaft a 1.55 OD/ID ratio has generally been deemed to result in the best balance of torque and volume.