standard curing

standard curing

Subjecting test specimens of concrete to specified conditions of temperature and moisture.
References in periodicals archive ?
Vista Dental Products announces VALIANT[R] PINK which uses pink light, a combination of red and standard blue light, that significantly improves micro-hardness and degree of conversion of composite materials while generating less heat than standard curing lights.
Using pink light, a combination of red and standard blue light, VALIANT PINK significantly improves microhardness and degree of conversion of composite materials plus generates less heat than standard curing lights.
At the end, the samples were subjected to standard curing. There was a difference between theoretical dry density and measured dry density for each density of foamed concrete; however, that difference is small.
Numerous studies have shown that [20-24], heat curing and autoclave curing can improve concrete strength compared to standard curing. Richard and Cheyrez [3] formulated RPC with a strength of up to 800 MPa with steel fibers (10% by volume) and steel aggregate at temperatures up to 400[degrees]C and pressures of 50 MPa.
Lower porosities were shown inside of GICs in heated and ultrasound cured restorations comparing to standard curing. (Figure 1) Heat cured GIC restorations appeared more homogenous.
It is envisaged that the capability will be approximately as described below; Oven suitable for aerospace standard curing of composite components with an internal capacity of approximately 20 m x 5 m and 3.5 m height.
The current standard curing and sintering approach uses a number of different systems to cure and sinter the inks.
Standard curing time adopted in studies was 20 seconds.20 Almost all materials found to be cured after 20 seconds curing time was found in another study.
The specimens were then demolded and cured under one of two curing conditions: standard curing (immersion in water at 23 [+ or -] 2[degrees]C) or autoclave curing.
Using pink light, a combination of near-infrared and standard blue light, VALIANT[R] PINK significantly improves micro-hardness of composite restorations and generates less heat than standard curing lights.
The standard curing (C1), most frequently used for NC, is selected.
There is great difference for the shrinkage between the steam curing and the standard curing. Studies showed that [5] the shrinkage of UHPFRC among 14 d age reached up to 400-800 [micro][epsilon] in the standard curing condition, while that of 28 d was only about 100-300 [mu][epsilon] in the curing condition of high-temperature steam.
Full browser ?