tempered water

tempered water

Water in the temperature range from 85°F (29°C) to 110°F (43°C).
Mentioned in ?
References in periodicals archive ?
The contract covers the following tasks: - re-examine the whole dossier, Urban and energy studies to confirm the technical feasibility of creating a tempered water loop, - make recommendations on the characteristics of the future contract to ensure its economic feasibility, - propose the content of the future dsp contract, - assist the city in the award of the dsp, - coordinate the technical interventions of the holder of the csp with the developer (and directly with the developer until the csp is notified); - monitor the performance of the contract for 3 years.
While the three chiller types are very similar, both the swing and tempered water chillers have larger evaporator shells and tube bundles to accommodate the higher chilled water flow rate required, not only by the larger capacity, but also by the inherently lower chilled water temperature rise available with the sensible only water-to-air heat transfer devices.
A thermostatic mixing valve with a built-in bypass can deliver tempered water in normal use and utilize a bypass for the thermal disinfection procedures.
tt starts with cheese curds, Victoria explains, which are diced, then soaked in tempered water at 180 degrees until they warm up.
We watched as its form faded from recognisable shape to a blurry discoloration in tempered water.
In pipe, anything above Schedule-40 wall thickness is a good point at which to think about going from cold water to tempered water to optimise cooling rates.
The temperature of the incoming sand is monitored and the necessary amount of properly tempered water is metered into the linear stainless steel cooling bundle to meet a discharge set point.
The long-distance collaboration between Heat and Control Pry's manufacturing site down under and Dorset-based Tetra Pak CPS resulted in a custom-built tempered water system with heat exchanger, pump and steam equipment on a process line for manufacturing crisps in the West Midlands.
Powers offers the LM490 and LM495 tempering valve series designed for lavatory, hot water heater, and multifixture and tempered water applications.
The piping was used for a variety of applications including chilled water, domestic water, process water, tempered water for safety showers and chilled glycol.
The centrifugal pellet dryer and tempered water system designs incorporate several unique features to enhance the attractiveness of this small system for laboratory use.
This valve provides a safe and plentiful supply of tempered water when used in conjunction with a potable hot water source.