torsional load

torsional load

The load that imparts the turning moment or the torque.
Mentioned in ?
References in periodicals archive ?
On the other hand the screws were assembled with tensile and torsional load on a multichannel assembly test stand at Uni Siegen, Figure 1.
[23.] Keykha, A.H., 3D Finite Element Analysis of Deficient Hollow Steel Beams Strengthened using CFRP Composite under Torsional Load, Composites: Mechanics, Computations, Applications, An International Journal, 8(4), 2017, pp.
The frame transfers four type of loads: Torsional load, Lateral load, Vertical load, and Longitudinal load [4].
According to the ISO specification, the 3 mm file tip was fixed with the brass and 2 rpm of rotational speed was applied to generate a torsional load. However, the test conditions to create torsional load by single rotation until fracture happens do not commonly happen in clinical situation.
As observed, strong similarity exists between the experimental curves of the axial and flexing loads and a small error in the curve for the torsional load; this difference is due to an inadequate selection of a parameter in the configuration of results.
This study aimed to examine contribution of torsional load to buckling of the osteoporotic lumbar L1 human vertebral body which was axially compressed by applying the finite element method.
The specimen was held fixed on one end, and torsional load was applied on the other end, as shown in Figure 13.
Torsional Load. NALCP maximum stress was situated in the lateral border of the number 5 countersink of the proximal plate (between the runner plate and the main plate locking screw).
This engine stand, developed from a unit with 20,000kg load capacity, can now reportedly accommodate a maximum torsional load of 80KNm, covering the extra stresses induced where the heavier load is rotated though a full 360[degrees] around the long axis.
The screw is also under torsional load from the drive, adding to the overall stress, since both bending and torsional stresses are at their maximum on the outer surface of the screw.
In order to determine the shear modulus, the DWNT must be subjected to a torsional load, i.e.
It consists of a transducer mounted on the shaft, which monitors variations in resonance frequency of a drive shaft as the torsional load varies and transmits a radio frequency signal to an adjacent pick-up.