wet collector

wet collector

[′wet kə′lek·tər]
(engineering)
Mentioned in ?
References in periodicals archive ?
During the wet deposition events, the sensor moves the lid onto the dry collector and after the sensor surface becomes dry, the lid on the dry collector goes onto the wet collector. The aluminum cylindrical container installed into the dry collector compartment was filled with 3 L of distilled water to collect both particulate and gas-phase PAHs.
"Although the NFPA doesn't specify the installation of a wet collector, there is a higher risk of fire with a dry filter," says Mike Sweezy, of Filter 1.
Grinding or polishing operations can create fine dust and must be ventilated, with the collector located outside the building, unless it is a wet collector. Dust must be removed from collectors daily and fines kept in sealed conductive containers.
Ideal for collecting light, sticky dusts that would normally clog fabric-type dust collectors, the RotoClone is the most cost-effective, high-efficiency wet collector available.
Improvements were made to reduce the excessive dust on the shop floor, including replacing a wet collector with a new baghouse system and adding high-wall exhaust fans in the core room to remove heat and stray gases.
The undisclosed acquisition includes the rights to manufacture the Carter range of dust extraction equipment which consists of dry dust filters, booths and benches and wet collectors.
The acquisition includes the rights to manufacture the Carter range of dust extraction equipment, which consists of dry dust filters, booths and benches and wet collectors.
Handte Vortex scrubbers operate at low internal pressure drop compared to venturitype wet collectors. Two horsepower ratings are available for standard and high-static pressure applications.
Handte Vortex scrubbers operate at low internal pressure drop compared to venturi-type wet collectors. Two horsepower ratings are available for standard and high static pressure applications.
Because the Dust Extraction Swing Arm can be mounted to Ruwac's portable dry vacuums as well as its line of explosion proof wet collectors, it makes it a very diverse vacuum accessory capable of safely removing everything from combustible metal dusts to grains, sugars and other fine powders.
Typical pollution control equipment may comprise mechanical separators, filtration devices, particulate scrubbers, wet collectors, electrostatic precipitators, gas absorbers and combustion incinerators.
These systems also have facilitated more effective extraction of active clay from the dust of wet collectors or baghouse collectors.